Enthalpy change of a displacement reaction Free Essay Example

1. Experiment Number: 4 2. Date: 15/10/07 3. Title: Enthalpy change of a displacement response 4. Aims/Objective: To figure out the enthalpy modification of a displacement reaction (In between zinc and copper (II) ions) 5. Introduction: Excess zinc powder is included in a measured quantity of aqueous copper (II) sulphate. The temperature level change is then measured over a time period so the enthalpy of this reaction can be determined. 6. Pertinent Equations/Chemical Reactions Involved: Zn (s) + CuSO4(aq)?? ZnSO4(aq) + Cu(s) 7. Chemicals: 1. 00M copper (II) sulphate option 25.

0 cm3 Zinc powder (in excess) 5. 9g.

8. Device and devices: Security phenomenon x 1 Spatula x 1 25 cm3 pipette x 1 Balance x 1 Pipette filler x 1 Thermometer(0-100 oC) x 1 Polystyrene cup with cover x 1 Digital timer x 1 Weighting bottle x 1 9. Treatment: 1. An empty polystyrene cup was weighted. 2. 5. 9g of zinc powder (in excess)was weighted and after that added into the polystyrene cup. 3. The temperature of the copper (II) sulphate solution in beaker was tape-recorded every half minute for 2. 5 minutes and after that 25.

0 cm3 of the copper (II) sulphate solution was pipetted into a polystyrene cup. 4. Thermometer was put through the hole of the cover.

The solution was stirred continuously and the temperature was tape-recorded every half minute for 6 minutes. 10. Observation: The blue colour of the option vanishes. Brown strong is formed. Some zinc powder remains there. 11. Information, Calculation and Results: a. Results Table Time/min 0. 0 0. 5 1. 0 1. 5 2. 0 2. 5 3. 0 3. 5 4. 0 4. 5 Temperature/oC 25. 0 25. 0 25. 0 25. 0 25. 0 25. 0 25. 0 60. 0 73. 0 71. 0 Time/min 5. 0 5. 5 6. 0 6. 5 7. 0 7. 5 8. 0 8. 5 9. 0 9. 5 Temperature/oC 69. 0 68. 0 67. 0 65. 5 64. 5 63. 5 62. 5 61. 5 60 59 b. Calculations 1&& 2. Graph of temperature against time.

3. Energy change of solution = 25 x 10-3 x 4. 18 x (76. 5 – 25) = 5. 38175 kJ mol-1 Energy change of the cup = 2.

27 x 10-3 x 1. 3 x (76. 5- 25) = 0. 1519765 kJ mol-1 Enthalpy change for the quantities used = – (5. 38175 + 0. 1519765) = – 5. 5337265 kJ mol-1 Assumptions : (1) The specific heat capacity of the solution is the same as that of water. (2) Heat is not lost to the surrounding. 4. No. of mole of CuSO4 = 1 x 25 x 10-3 = 0. 025 mol Required enthalpy change = – [(5. 5337265)/0. 025] = – 221 kJ mol-1 Zn (s) + CuSO4(aq) ?? ZnSO4(aq) + Cu(s) ? H = – 221 kJ mol-1 12. Conclusion :

It was found that the enthalpy change of a displacement reaction (Between zinc and copper (II) ions) was – 221 kJ mol-1. 13. Answer to questions 1. % error = {[- 221 – (- 217)]/- 217 }x 100% = 1. 84% The experimental value is more negative than the accepted value. 2. Reasons : (1) Heat is lost to the surrounding. (2) The specific heat capacity of the solution is not the same as that of water. 3. CuSO4 is not in excess which is used up totally. No matter that more zinc is used or powder is very finely divided, same amount of the solution is used so there is same increase in temperature.

Remember! This is just a sample.

You can get a custom paper by one of our expert writers.

Get your custom essay

Helping students since 2015