Waste Management In Mauritius Environmental Sciences Essay Free Essay Example

Mauritius has known a rapid economic growing which gave rise to a considerable alteration in the types and volume of waste generated by the different sectors of the economic system annually. One of the most of import environmental concerns both on the island of Mauritius or Rodrigues is without uncertainty the proper aggregation, storage and disposal of industrial, commercial and municipal solid waste.

Human produces stuffs from its assorted activities which are normally excess and thrown off, known as solid waste and is estimated to be around 1200 metric tons per twenty-four hours.

On norm, a Mauritanian produces 1 kilogram of solid waste per twenty-four hours. In 2003, harmonizing to the Ministry of Environment and National Development Unit, there were 372, 434 dozenss of solid waste landfilled at the lone landfill of the state situated at Mare-Chicose. The composing of solid waste is shown in the tabular array below.

Table 1: Composition of solid waste ( www.gov.mu )

Components

Composition, %

Kitchen waste

45

Yard waste

25

Paper

10

Plastics

9

Fabric

4

Glass

3

Metallic element

2

Other

2

Waste aggregation is carried out in Mauritius by the local governments dwelling of 5 municipalities for urban countries and 4 territory councils for rural parts.

In 1991, there were 145 vehicles and a labour force of 2500 roll uping 524 metric tons of waste on a day-to-day footing although the State of the Environment Report 1991 does reference that this figure could be grossly underestimated.

Beginnings and types of solid waste

Table 2: Beginnings and types of waste ( adapted from Hoornweg. D and Thomas. L 1999. )

Beginning

Typical waste generators

Types of solid wastes

Residential

Single and multifamily homes

Food wastes, paper, composition board, plastics, fabrics, leather, pace wastes, wood, glass, metals, ashes, particular wastes ( e.

g. , bulky points, consumer electronics, white goods, batteries, oil, tyres ) , and household risky wastes. ) .

Industrial

Light and heavy fabrication, fiction, building sites, power and chemical workss.

Housekeeping wastes, packaging, nutrient wastes, building and destruction stuffs, risky wastes, ashes, particular wastes.

Commercial

Shops, hotels, eating houses, markets, office edifices, etc.

Paper, composition board, plastics, wood, nutrient wastes, glass, metals, particular wastes, risky wastes.

Institutional

Schools, infirmaries, prisons, authorities centres.

Same as commercial.

Construction and destruction

New building sites, route fix, redevelopment sites, destruction of edifices

Wood, steel, concrete, soil, etc.

Municipal services

Street cleansing, landscape gardening, Parkss, beaches, other recreational countries, H2O and effluent intervention workss.

Street sweepings ; landscape and tree fixingss ; general wastes from Parkss, beaches, and other recreational countries ; sludge.

Process ( fabrication, etc. )

Heavy and light fabrication, refineries, chemical workss, power workss, mineral extraction and processing.

Industrial procedure wastes, bit stuffs, off-specification merchandises, slay, shadowings.

Agribusiness

Crops, groves, vineries, dairies, feedlots, farms.

Spoiled nutrient wastes, agricultural wastes, risky wastes ( e.g. , pesticides ) .

All those waste one time collected demands to be decently disposed and this can be done in different ways: –

It can be sent to reassign Stationss, so to landfills,

it can be incinerated,

recycled,

composted.

Figure 1: Solid waste direction hierarchy ( adapted from Earth 911 by Raquel Fagan 2009 )

Since Mauritius has got merely one landfill station and there have been important addition in waste production, other methods of waste disposal should be used as shown above. However those waste disposal methods are non hundred per centum feasible, as there are different types of waste which will ever ensue in a per centum of them traveling to the landfill at the terminal of the twenty-four hours. But the existent concern remain the minimization of waste whether at beginning or through those disposal methods.

Segregation is the really first measure towards waste disposal so that the latter can be recycled, incinerated or composted, as each type of waste is treated otherwise. Plastic bottles, tins and so on are chiefly recycled while yard waste and kitchen waste can be composted, and medical wastes are most of the clip incinerated.

Incinerators have been chiefly introduced as it reduces most of the waste to ashes hence less waste is sent to landfills. However the byproducts obtained can non be re-used as in the recycling and composting method ; but is really efficient in low risky or scheduled waste such as blood-soaked or saliva-soaked cotton axial rotations, surgically-removed hard- and soft-tissues. While extremely risky stuffs such as sharps and panpipes or waste incorporating heavy metals are sent to cells situated at Mare-Chicose.

Incinerators can besides be waste to energy, that is waste burned in the incinerator can be converted into energy for illustration to bring forth low scale electricity. But nevertheless incinerators need to be extremely advanced as it needs to let go of low degree of risky substances and less ash to dispose.

Components of an incineration system

Achieving coveted temperatures, abode times, and other conditions necessary to destruct pathogens, minimise emanations, avoid cinder formation and slagging of the ash ( in the primary chamber ) , avoid furnace lining harm devastation, and minimise fuel ingestion are the demands of a proper incinerator. Dioxin and furan emanations should besides be controlled through good burning patterns.

The chief constituents of an incinerator are:

Combustion chambers- it is usually constructed of an outer shell and an interior stubborn stuff liner which encloses the burning country. In the beginning burning occurs in the primary chamber, where air is supplied by a burning air provider. Further burning of the gases occurs in the secondary burning chamber usually situated above the primary chamber.

Burners- Burners aid in the burning of the waste through ignition. It besides maintains the needed temperature to cut down emanations. Incinerator burners may be natural gas, oil fired or electrical.

Fans- Centrifugal fans for incinerator systems is provided to provide burning air or to help in wash uping the shaft gases from the incinerator to the chimney.

Hazards and wellness effects of incinerators

1. Particulates

Incinerators generate immense measures of all right and ultrafine particulates that are classified by size. The rate at which incinerators are allowed to breathe particulates is 10mg /m3 of gaseous discharge. Filters are used which allow the smallest particulates to acquire through and barricading larger 1s which are less unsafe.

The nose and bronchioles do non filtrate the smaller atoms and are hence voiceless profoundly into the lungs and absorbed straight into the blood watercourse where they can stay for hours and this can impact the cell ‘s Deoxyribonucleic acid.

2. Heavy metals

Metallic elements are emitted from metallic waste, plastics and many other substances due to high temperatures of incinerators. Emissions and ash from incinerators contain over 35 metals. The proportion of heavy metals emitted from autos is well less every bit compared to those allowed to be emitted by incinerators. Some of the heavy metals released, such as Cd, can be toxic at really low concentrations.

Several metals are known or suspected to do malignant neoplastic disease and they build up in the organic structure with increasing age and remain for old ages: Cd has a 30 twelvemonth half life

3. Nitrogen oxides

Merely an norm of 60 % of azotic oxide is removed during incineration and the remaining is so transformed to nitrogen dioxide organizing smog and acerb rain. Action of sunshine on azotic oxides produces another pollutant, ozone.

Nitrogen dioxide causes a assortment of effects in the lungs, in the lien, liver and blood in carnal surveies. Both reversible and irreversible effects in the lungs have been noted.

4. Organic pollutants

A big scope of organic pollutants is released from incinerators chiefly dioxins and furans. There has been a considerable alteration in the composing of waste as compared to those in the yesteryear. Nowadays there is a much higher concentration of heavy metals and plastics doing more injury for wellness and the environment for illustration polyvinyl chloride ( PVC ) , made of more than 90 % organic Cl.

These substances are lipotropic and tend to roll up in fatty tissue and staying dynamic in populating beings and the environment for a long clip. They have been associated with chest malignant neoplastic disease, adenomyosis, reduced sperm counts, early pubescence and other upsets of male generative tissues, testicular malignant neoplastic disease and thyroid break.

Hazard Appraisal

There are four phases in a hazard appraisal procedure viz. :

jeopardy designation

exposure appraisal

toxicity appraisal

hazard word picture

Hazard designation

In hazard designation, contributory agents are identified and the likeliness of relationships and mechanisms between air pollutants and harmful wellness effects are established. A list of precedence has been created utilizing collected informations.

Exposure appraisal

The exposure assessment musca volitanss exposed populations and give information about the type, degree, continuance and frequence of exposure. Normally, exposure appraisal consists of a figure of stairss:

aˆ? Evaluation of ambient air concentrations,

aˆ? Classification of any particular groups,

aˆ? Development of suited exposure premises,

aˆ? Assessment of the Numberss of open persons based on demographic and other informations.

aˆ? Validation of exposure survey utilizing monitoring or other agencies.

Toxicity appraisal

The badness of the chemicals are identified utilizing theoretical accounts based on human ( including clinical and epidemiologic attacks ) , and carnal surveies is carried through toxicity appraisal. The dose response relationships depend on the pollutants viz. :

Systemic poisons,

Carcinogens,

“ Conventional ” pollutants.

Hazard word picture

The general hazards of exposure are established by the hazard word picture method. For each chemical and affected population, the relation between the dose-response relationship, pollutant exposure, and population exposed are analyzed. This is done to place major pollutants doing hazards, the magnitude of the hazard, the populations with the maximal hazard, and the figure of people apt to be affected.

Risk appraisal methods

Hazard are identified and so classified in order of likeliness and impact.

Some normally used hazard appraisal methods are:

Issued based- in this method a undertaking is subdivided into several parts that cover certain issues.

Scoring- This method gives us a value that indicates the degree of hazard and is normally based upon puting a threshold value e.g. on a degree of 1 to 10

Checklist- it is a simple hazard appraisal method which is non thorough and do non give an thought of the overall hazard.

Quantitative- This hazard direction method make usage of already bing programs. Evaluation is done utilizing appropriate package.

Objective of study

In the past few old ages, public concern over the disposal of waste has markedly increased. The increasing concerns over chiefly medical waste disposal were stimulated by studies which shows the harmful impact medical wastes have when utilizing incinerators.

Our chief aims were:

Analyzing the current province of bing incinerators,

Measuring the hazards and jeopardies of medical waste on operators, patients and the vicinity,

Developing the appropriate direction patterns for medical waste incinerators, whereby necessary recommendations sing wellness and safety issues would be suggested.

With the information collected through the hazard assessment a study will be created.